An engineer must design AP placements for a new branch office that contains two floors. The engineer uses Ekahau to complete the predictive survey. To calculate the signal bleed through between floors, the engineer creates a building, adds the floors, and attenuation areas. After the scale is set, what else must be added on the floors to accurately measure the signal bleed at a specific location?

• A. Choose the access point models.
• B. Start the auto planner.
• C. Draw in coverage areas.
• D. Add alignment points.

In a FlexConnect deployment, which role does the site tag play?

• A. It manages the firewall policies for the site APs.
• B. It assigns IP addresses to wireless clients for the site APs.
• C. It configures the switch port settings for FlexConnect APs.
• D. It defines the roaming domain for FlexConnect APs.

The wireless team must configure a new voice SSID for optimized roaming across multiple WLCs with Cisco 8821 phones. Which two settings accomplish this goal? (Choose two.)

• A. Configure mobility groups between WLCs.
• B. Use Cisco Centralized Key Management for authentication.
• C. Configure AVC profile on new SSID.
• D. Use AVC to tag traffic voice traffic as best effort.
• E. Configure AP groups between WLCs.

A customer wants a network engineer to design a Cisco wireless solution that will have redundancy through SSO and LAG. APs in the executive office must reassociate to the WLC as soon as possible in the event of a failure. The WLCs are located in a remote data center. The head office uses a WAN for connectivity with the data center. Which priority must be incorporated in the design to be assigned to the executive APs?

• A. critical
• B. low
• C. high
• D. medium

An engineer is designing a wireless solution for a corporate campus which includes two primary buildings: Research and Operations. The design must ensure seamless mobility for employees moving between buildings, support uninterrupted connectivity for real-time applications, and facilitate efficient Layer 2 and Layer 3 roaming. Each building's 9800-80 WLC manages its local APs, and the solution must support 802.11r/k/v while maintaining an effective mobility control plane. Which design approach leverages Cisco mobility group architecture to meet the requirements?

• A. Add both 9800-80 WLCs in a single mobility group with no specific roles assigned, enabling peer- to-peer coordination for seamless roaming across buildings.
• B. Assign each 9800-80 WLC to separate mobility groups, one for each building, to isolate traffic and mitigate the risk of overloading a single mobility group.
• C. Establish the Operations building's WLC as an anchor controller, configuring the Research building's WLC to tunnel all client traffic to it for centralized traffic management.
• D. Designate the Research building's WLC as the primary controller and the Operations building's WLC as a secondary controller within a single mobility group to centralize mobility management.