Refer to the exhibits. The exhibits show two IPsec templates to define Branch IPsec 1 and Branch_IPsec_2. Each template defines a VPN tunnel. The error message that FortiManager displayed when the administrator tried to assign the second template to the FortiGate device is also shown. Which statement best describes the cause of the issue?

• A. You can assign only one template with a tunnel type of static to each FortiGate device.
• B. You can assign only one IPsec template to each FortiGate device.
• C. You should use the same outgoing interface of both templates.
• D. You should review the branch1_fgt configuration for configured tunnels in the root VDOM.

FortiManager SD-WAN overlay orchestrator helps prepare SD-WAN deployments. To complete the tasks performed by the SD-WAN overlay orchestrator, you must perform some post-run tasks.
Which two mandatory post-run tasks must you perform? (Choose two.)

• A. Assign a hub_id metadata variable to each hub device.
• B. Assign an sdwan_id metadata variable to each device (branch and hub).
• C. Create policy packages and assign them to the branch devices.
• D. Configure SD-WAN rules.
• E. Configure routing through the overlay tunnels created by the SD-WAN overlay template.

You manage an SD-WAN topology and you will soon deploy 50 new branches.
Which two tasks can you do in advance to simplify this deployment? (Choose two.)

• A. Define metadata variable values for each device.
• B. Create a policy blueprint.
• C. Create model devices.
• D. Create a zero-touch provisioning (ZTP) template.

As an IT manager, you want to delegate the installation and management of your SD-WAN deployment to a managed security service provider (MSSP).
Each site must maintain direct internet access and be secure. You expect significant traffic flow between the sites and want to delegate as much of the network administration and management as possible to the MSSP.
Which two MSSP deployment blueprints address your requirements? (Choose two.)

• A. Install a dedicated hub at the MSSP premises for the new customer, and install the spokes at the customer premises.
• B. Use a shared hub at the MSSP premises with a dedicated VDOM for the new customer, and install the spokes at the customer premises.
• C. Use a shared hub at the MSSP premises and a dedicated hub at the customer premises and install the spokes at the customer premises.
• D. Install the hub and spokes at the customer premises and enable the MSSP to manage the SD- WAN deployment using FortiManager with a dedicated ADOM.

You want to configure SD-WAN on a few FortiGate devices to optimize the use of WAN links and secure internet access. The devices are standalone FortiGate, already centrally managed by FortiManager. Which statement applies?

• A. You can keep the devices in the Device Manager section. You can configure per-device SD-WAN settings.
• B. You must move the devices to the SD-WAN Manager section and use the SD-WAN standalone wizard.
• C. You must move the devices to the SD-WAN Manager section before you can configure SD-WAN rules.
• D. You can keep the devices in the Device Manager section, but you must place them in a dedicated device group.