[Dec-2021] 350-501 Dumps are Available for Instant Access using DumpsActual
350-501 Dumps 2021 - New Cisco 350-501 Exam Questions
NEW QUESTION 42
Drag and drop the functionalities from the left onto the correct target fields on the right.
Answer:
Explanation:
NEW QUESTION 43
What are two characteristics of MPLS TE turrets? (Choose two)
- A. They use RSVP to provide bandwidth for the tunnel.
- B. They require EIGRP to be running in the core.
- C. The headend and tailend routes of the tunnel must have a BGP relationship
- D. They are run over Ethernet cores only.
- E. They are unidirectional
Answer: A,E
NEW QUESTION 44
A network engineer is deploying VRF on ASBR router R1. The interface must have connectivity over an MPLS VPN Inter-AS Option AB network. Which configuration must the engineer apply on the router to accomplish this task?
- A.
- B.
- C.
- D.
Answer: A
Explanation:
Section: Networking
NEW QUESTION 45
Refer to the exhibit:
A network engineer is implementing a BGP protocol. Which effect of the local-as keyword in this configuration is true?
- A. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 without additional configuration.
- B. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 without additional configuration
- C. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65112 and the VPNv4 address family
- D. It enables peer 192.168.1.2 to establish a BGP relationship with R1 using AS 65012 and the VPNv4 address family
Answer: A
NEW QUESTION 46
Refer to the exhibit:
An engineer wants to authenticate the OSPF neighbor between PEA and PE-B using MD5.
Which command on PE-B successfully completes the configuration?
A)
B)
C)
D)
- A. Option C
- B. Option A
- C. Option B
- D. Option D
Answer: B
NEW QUESTION 47
Which statement about Network Services Orchestrator (NSO) is true?
- A. It uses YANG modeling language to automate devices
- B. It is used only in service provider environments
- C. It must use SDN as an overlay for addressing
- D. It can be used only with XML coding
Answer: A
NEW QUESTION 48
When configuring traffic engineering tunnels in Cisco MPLS core network, you see the traffic is not taking the expected path in the core.
Which command do you use to quickly check path of a TE tunnel?
- A. traceroute <tunnel destination IP>
- B. Ping <tunnel destination IP>
- C. show mpls traffic-engineering tunnels
- D. Traceroute mpls ipv4 -tunnel destination
Answer: C
NEW QUESTION 49
Refer to the exhibit.
CE1 and CE2 require connectivity to the internet through the ISP connected to PE3 What should an engineer configure to complete this task?
- A. PE2 must be configured to serve as a route reflector for PE3 routes learned from the internet. PE2 then shares the routes with CE1 and CE2.
- B. CE1 and CE2 must be configured with a route distinguisher in the PE1 VRF that dynamically imports the route from the internet.
- C. CE1 and CE2 must be configured to use a static default route with a next-hop of PE3 to reach internet routes.
- D. PE1 must be configured with an import route target in the CE1 VRF that matches the export route target for the internet VRF on PE3.
Answer: A
NEW QUESTION 50 
Refer to the exhibit. What type of configuration is it?
- A. It is configuration that requires an explicit Cisco MPLS TE path to be configured for the tunnel to run
- B. It is configuration for the head-end router of a Cisco MPLS TE tunnel with segment routing
- C. It is configuration that requires a dynamic Cisco MPLS TE path to be configured for the tunnel to run
- D. It is configuration that requires OSPF to also be running to have optimized Cisco MPLS TE tunnels
Answer: B
Explanation:
Section: MPLS and Segment Routing
NEW QUESTION 51 
Refer to the exhibit. A network engineer is configuring MPLS LDP synchronization on router R1. Which additional configuration must an engineer apply to R1 so that it will synchronize to OSPF process 1?
- A.
- B.
- C.
- D.
Answer: A
Explanation:
Section: MPLS and Segment Routing
NEW QUESTION 52
Which configuration enables BGP FlowSpec client function and installation of policies on all local interfaces?
A)
B)
C)
D)
- A. Option A
- B. Option B
- C. Option C
- D. Option D
Answer: C
NEW QUESTION 53
Drag and drop the technologies from the left onto the correct definitions on the right.
Answer:
Explanation:
NEW QUESTION 54
Refer to the exhibit:
Which effect of this configuration is true?
- A. The two routers fail to form a neighbor relationship because the authentication configuration is missing
- B. The two routers fail to form a neighbor relationship because their system IDs are different.
- C. The two routers fail to form a neighbor relationship because they have different ISIS area types.
- D. The two routers successfully form a neighbor relationship
Answer: D
NEW QUESTION 55
Refer to the exhibit:
An engineer wants to authenticate the OSPF neighbor between PEA and PE-B using MD5.
Which command on PE-B successfully completes the configuration?
A)
B)
C)
D)
- A. Option C
- B. Option A
- C. Option B
- D. Option D
Answer: B
NEW QUESTION 56
Refer to the exhibit.
Which show command should be implemented to display per-interface statistics about uRPF drops and suppressed drops?
- A. show cef interface
- B. show ip interface brief
- C. showip interface
- D. show ip traffic
Answer: C
NEW QUESTION 57
Refer to the exhibit:
Which configuration prevents the OSPF neighbor from establishing?
- A. duplex
- B. mtu
- C. network statement
- D. default-metric
Answer: B
NEW QUESTION 58 
Refer to the exhibit. This configuration is being applied on an IOS XR route.
Which statement about this configuration is true?
- A. It is used to identify MIB entries and has a list of YANG models.
- B. It is used to create a subscription to specify the streaming interval.
- C. It is used to identify traps for SNMP polling.
- D. It is used to create a sensor-group and has a list of YANG models for streaming.
Answer: D
Explanation:
Section: Automation and Assurance
Explanation/Reference:
Reference; https://www.cisco.com/c/en/us/td/docs/routers/ncs6000/software/telemetry/b-telemetry-cg-ncs6000-
62x/b-telemetry-cg-ncs6000-62x_chapter_010.pdf
NEW QUESTION 59
Refer to the exhibit.
An engineer must configure router R2 as the new P router in the network. Which configuration must be applied to R2 to enable LDP-IGP Sync on its L2 IS-IS adjacencies?
A)
B)
C)
D)
- A. Option
- B. Option
- C. Option
- D. Option
Answer: D
NEW QUESTION 60
Drag and drop the OSs from the left onto the correct descnpt.ons on the right.
Answer:
Explanation:
NEW QUESTION 61
An engineer working for a private telecommunication company with an employee id: 3948:11:613 needs to limit the malicious traffic on their network. Which configuration must the engineer use to implement URPF loose mode on the GigabitEthernetO/1 interface?
A)
B)
C)
D)
- A. Option
- B. Option
- C. Option
- D. Option
Answer: B
Explanation:
Explanation
"reachable-via any" must be configured for Loose mode on both IPv4 & IPv6.
https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_data_urpf/configuration/xe-3s/sec-data-urpf-xe-3s-book/s
NEW QUESTION 62 
Refer to the exhibit. An engineer is preparing to implement link aggregation configuration.
Which statement about this configuration is true?
- A. The switch port negotiates an EtherChannel if it receives LACP packets from a connected peer running passive mode.
- B. The switch port accepts LACP and PAgP packets from a connected peer and negotiate an EtherChannel using the common EtherChannel mode.
- C. The switch port actively sends packets to negotiate an EtherChannel using PAgP.
- D. The switch port passively negotiates an EtherChannel if it receives PAgP packets from a connected peer.
Answer: C
Explanation:
Section: Networking
Explanation/Reference: https://www.cisco.com/en/US/docs/switches/metro/me3600x_3800x/trash/swethchl.html
NEW QUESTION 63 
Refer to the exhibit. A network engineer is configuring customer edge routers to finalize a L2VPN over MPLS deployment. Assume that the AToM L2VPN service that connects the two CEs is configured correctly on the service provider network.
Which action causes the solution to fail?
- A. The routing protocol network types are not compatible.
- B. The xconnect statement has not been defined.
- C. A loopback with a /32 IP address has not been used.
- D. OSPF does not work with L2VPN services.
Answer: A
Explanation:
Section: Architecture
NEW QUESTION 64
......
Who should take the Cisco 350-501: Implementing and Operating Cisco Service Provider Network Core Technologies Exam
People who wish to explore the power of the dynamic culture of the Cisco Learning Network to jump-start their certification and lifelong learning goals should take this exam. Those who want to get useful tools for IT training for all Cisco certifications should also get this certification. People with prior knowledge of integrating VPN services, including Layer 2, Layer 3, and IPv6, from the service provider are highly recommended to take this exam and get themselves certified from Cisco.
List of the target audience for this exam:
- Network designers
- Network Operations Center (NOC) personnel
- Network architects
- Network managers
- Network supervisors
- Channel partners
- Network engineers
- Network administrators
Cisco 350-501 Exam Practice Test Questions: https://www.dumpsactual.com/350-501-actualtests-dumps.html
Free 350-501 Braindumps Download Updated: https://drive.google.com/open?id=1FXqAYX8WZge2GVVZd66EWGpaY37Q_jP6
